Panels could be a time -saver when placing siding on a home as the sheets — usually 4 by 8-feet — increase faster than personal boards. Panel siding is exterior-grade plywood, , such some hard-board both 1/2 or 5/8 inch-thick, or as cement-fiber. Finishes are accessible to emulate wood planks tough cedar or textures. Some panel siding is installed with wood battens over seams, while other panels have tongueandgroove joints to create a surface that is good. Installation is simply the the same regardless of how panels are linked.
Put steel caulk and flashing around all windows, doorways and other openings, including vents. Fasten flashing using a nails. Use a caulking gun to to put a bead of caulk in most gaps. Cover the walls with rigid foam board insulation, fixed to wall studs or sheathing with wide- headed nails that have washers underneath the heads.
Wrap the home with using a polystyrene moisture barrier, fixed via the foam board to wall studs -capped nails. Use a suitable tape to seal seams at home wrap joints and around doorways, windows and other openings.
Measure the wall peak using a tape measure and mark starting-points for panels on the underside of the wall, to comply with the 8 foot size. Snap a level chalk line throughout the home at that level. Install 2 by-2 inch ledger boards along that line to offer a foundation for the panels. Cut ledgers using a circular saw or table saw as required to to match and nail them with 16d framing nails to the bottom plates of the partitions, examining each ledger with an amount to keep the bottom level..
Paint all edges of panels with primer, even in the event the panels are currently completed. Set an initial panel on a ledger in a corner about 1/4 inch from the wall finish., of the home Use an amount to get the edge plumb; change the gap somewhat as-needed to make the panel plumb. Nail the panel to the wall studs and leading and bottom plates a-T least 3 nails in every single stud. Set the nail heads having a nail-set.
Add panels, connecting with groove and tongue edges or butt joints to be coated with batten boards. Use a-level to keep panels plumb and le Vel. Use a jig-saw to reduce panels asneeded around doorways, windows and other openings; use a framing square to mark lines and calculate the the room vigilantly. Allow a minor gap a-T windows and doorways, by molding to be covered.
Rip panels length wise on a tablesaw to to match a-T corners. Measure the the room before cutting, and mark the panel specifically; have assist to guide a panel through the observed. Allow A1/4inch gap on every side of a a large part allowing enlargement. Before nailing panels in location paint cut edges.
Finish the siding with molding, usually 1-by-4inch boards, around doorways and on and windows corners. Put 1-by-4 boards, quarterround or other molding along the bottom and along the tops of the wall panels. Batten boards for that kind of siding over panel joints. Use finishing nails for items and set the nail heads. Fill all nail holes, with wood filler or caulk, on trim and siding.